Input Tray Tests
Input Tray Feed Test
This test lets the servicer observe the paper path as media is feed-
ing through the printer. A blank sheet of paper feeds through the
printer as the laser turns off during this test. The only way to observe
the paper path is to open the lower front door that is used to access
the multipurpose feeder. The paper is placed in the output bin.
To run the Input Tray Feed Test:
1. Select Input Tray Feed Test from the menu.
2. Select the input source from the sources displayed on the
Feeds Test menu. All installed sources are listed.
3. Select either Single (feeds one sheet of media from the selected
source) or Continuous (continues feeding media from the
selected source until Return or Stop is pressed).
4. Press Return or Stop to exit test.
Input Tray Sensor Test
This test is used to determine if the input tray sensors are working
correctly.
To run the Input Tray Sensor Test:
1. Select the Sensor Test from the Input Tray Tests menu.
2. Select the input source from the sources displayed on the Sen-
sor Test Menu
•
"Input Tray/EM=xx Size=xxx" displays.
•
EM = Input Tray Empty Sensor
•
Size = Input Tray Size Sensor
3. Once this message displays, you can manually actuate each
sensor. To view a valid EM sensor value, you must manually
press the paper size sensor tabs to select a valid tray size. If you
do not select a valid tray size, the empty tray sensor will display
?? and the size sensor will display - - -. When the tray is out of
paper, the empty tray sensor closes and EM=CL displays. When
the tray contains paper, the empty tray sensor is open and
EM=OP displays.
3-10