4. Press Return or Stop to exit the test.
The multipurpose tray does not have a paper low sensor.
Base Sensor Test
This test is used to determine if the sensors located inside the
printer are working correctly.
The following sensors can be checked:
Standard Bin Full
Upper Front Door Open
Rear Door Open (paper guide)
To run the Base Sensor Test:
1. Select the sensor you want from Base Sensor Test. The opera-
tor panel displays OP for open and CL for closed.
2. Manually toggle the sensors by hand to verify that each sensor
switches from open to closed. The standard bin sensor requires
about six seconds to activate.
3. Press Return or Stop to exit the test.
Print Registration
The print registration range is as follows:
Bottom Margin: -7 to +8
Top Margin: -20 to +20
Left Margin: -23 to +23
Manual Top: -20 to +20
To set Print Registration:
1. Select Registration from the Diagnostic menu.
2. The Top margin sign/value pair flashes. This indicates it is the
margin value being changed.
3. To select the margin value to be changed press Select until the
margin value pair you want to change is blinking.
4. To change the margin value press either Menu+ or Menu-.
Diagnostic Aids 3-11