Viewing The Permanent Page Count; Setting Configuration Id - Lexmark 11A4006 - Optra K 1220 B/W Laser Printer Service Manual

Viewing the Permanent Page Count

The Permanent Page Count can only be viewed and cannot be
changed.
To view the Permanent Page Count:
1. Select Permanent Page Count from the menu.
2. Press Return to exit the diagnostic menu.

Setting Configuration ID

The configuration ID is used to communicate information about cer-
tain areas of the printer that cannot be determined using hardware
sensors. The Configuration ID is originally set at the factory when
the printer is manufactured, however it requires resetting whenever
you replace the engine board and can be set on the operator panel.
However the Configuration ID is the only diagnostic function dis-
played until a valid ID is entered.
To set the Configuration ID:
1. Select Configuration ID from the Printer Setup menu.
•
The current ID displays on the screen. The Configuration ID
for the 4046-001 is 000303. The ID code for other models
with different configurations is on a label located on the con-
troller board cage. Remove the right cover and open the card
cage to see the label.
•
The leftmost digit flashes indicating that it is the first digit to
be changed.
2. To change the value, press either Menu+ or Menu- until the
value you want is reached. Press Select to move to the next
digit, or press Select again to skip a digit. Change each digit as
required. When the last digit is changed, press Select to vali-
date the Configuration ID. If the ID is invalid then "INVALID ID"
message displays on Line 2 before the ID displays again. You
have to reenter the Configuration ID until a valid ID is verified. If
the ID is valid then the ID is saved in NVRAM and the printer
automatically PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.
Diagnostic Aids 3-13