Table of Contents
Advertisement
Exit Paper Feed Roller Assembly Removal
1. Remove the right side cover.
2. Open the controller board cage door assembly and disconnect
the process fan from the engine board.
3. Remove the fuser and power supply board assembly.
4. Remove the paper feed guide assembly.
5. Remove the process fan/plate assembly (2 screws).
6. Remove the six gears.
7. Remove the right side paper feed frame.
8. Remove the exit paper feed roller assembly.
Installation Note:
1. To prevent damage to the pick motor cable and cover open
switch cable be sure they are placed above the interconnect
card.
2. Return the gears to the original position and install the process
fan/plate assembly to hold them in place.
3. Be sure to fasten the fan to the plate so the air flow arrow is in
the outward direction.
4-10
Advertisement
Table of Contents
