Viewing Routing Path Information - HP A7533A - Brocade 4Gb SAN Switch Base User Manual

Viewing routing path information

The topologyShow and uRouteShow commands provide information about the routing path.
1. Connect to the switch and log in as admin.
2. Issue the topologyShow command to display the fabric topology, as it appears to the local switch.
The following entries appear:
Local Domain ID
Domain
Metric
Name
Path Count
Hops
Out Port
In Ports
Total Bandwidth
Bandwidth Demand The maximum bandwidth demand of the in ports
Flags
For example:
switch:admin> topologyshow
2 domains in the fabric; Local Domain ID: 1
Domain: 6
Metric: 500
Name: switch
Path Count: 4
Hops: 1
Out Port: 60
In Ports: None
Total Bandwidth: 2 Gbps
Bandwidth Demand: 0%
Flags: D
Hops: 1
Out Port: 61
In Ports: None
Total Bandwidth: 2 Gbps
Bandwidth Demand: 0%
Flags: D
Hops: 1
Out Port: 62
In Ports: None
Total Bandwidth: 2 Gbps
Bandwidth Demand: 0%
Flags: D
Hops: 1
Out Port: 58
In Ports: None
Total Bandwidth: 2 Gbps
Bandwidth Demand: 0%
Flags: D
100 Routing traffic
Domain number of the local switch
Domain number of the destination switch
Cost of reaching the destination domain
The name of the destination switch
The number of currently active paths to the destination domain
The maximum number of hops to reach the destination domain.
The Port to which the incoming frame will be forwarded in order
to reach the destination domain
Input ports that use the corresponding Out Port to reach the
destination domain
The maximum bandwidth of the out port
Always D, indicating a dynamic path