Displaying Information; Link Incidents; Registered Listeners; Node Identification Data - HP A7533A - Brocade 4Gb SAN Switch Base User Manual

7. Respond to the remaining prompts (or press Ctrl-d to accept the other settings and exit).
8. Issue the switchEnable command to reenable the switch.
For example:
switch:admin> configure
Configure...
Fabric parameters (yes, y, no, n): [no] yes
Domain: (1..239) [3] 5
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
VC Encoded Address Mode: (0..1) [0]
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
BB credit: (1..16) [16]
Insistent Domain ID Mode (yes, y, no, n): [no] y
Virtual Channel parameters (yes, y, no, n): [no]
Switch Operating Mode (yes, y, no, n): [no]
Zoning Operation parameters (yes, y, no, n): [no]
RSCN Transmission Mode (yes, y, no, n): [no]
Arbitrated Loop parameters (yes, y, no, n): [no]
System services (yes, y, no, n): [no]
Portlog events enable (yes, y, no, n): [no]
Committing configuration...done.
switch:admin>

Displaying information

You can display link incidents, registered listeners, node identification data, and FRU failures, as
described in the following procedures.

Link incidents

The RLIR Extended Link Service (ELS) contains the link incident information sent to a listener N_Port.
To display link incidents, connect to the switch, log in as user, and issue one of the following commands:
• For the local switch: ficonshow rlir
• For all switches defined in the fabric: ficonshow rlir fabric

Registered listeners

To display registered listeners for link incidents, connect to the switch, log in as user, and issue one of the
following commands:
• For the local switch: ficonshow lirr
• For all switches defined in the fabric: ficonshow lirr fabric

Node identification data

To display node-identification data, connect to the switch, log in as user, and issue any of the
following commands:
• For the local switch: ficonshow switchrnid
• For all switches defined in the fabric: ficonshow switchrnid fabric
• For all devices registered with the local switch: ficonshow rnid
• For all devices registered with all switches defined in the fabric: ficonshow rnid fabric
110 Administering FICON fabrics