HP A7533A - Brocade 4Gb SAN Switch Base User Manual page 84

10.Respond to the prompts as follows:
Server
Name or IP
Address
User name
File name
Password
The firmware is downloaded to one CP blade at a time, beginning with the standby CP blade. During
the process, the active CP blade is failed over. After the firmware is downloaded, a firmware commit
starts on both CP blades. The entire firmware download and commit process takes approximately 35
minutes.
11.Optional: After the failover, connect to the switch and log in again as admin.
12.Using a separate telnet session, issue the firmwareDownloadStatus command to monitor the
firmware download status.
13.Issue the firmwareShow command to display the new firmware versions.
For example:
switch:admin> firmwaredownload
This command will upgrade both CPs in the switch. If you
what to upgrade a single CP only, please use -s option.
You can run firmwareDownloadStatus to get the status
of this command.
This command will cause the active CP to reset and will
require that existing telnet, secure telnet, or SSH sessions
be restarted.
Do you want to continue [Y]: y
Server Name or IP Address: 192.1.2.3
User Name: JohnDoe
File Name: /pub/v5.0.1/release.plist
Password:*****
FirmwareDownload has started on Standby CP. It may take up to 30 minutes.
Firmwaredownload has completed successfully on Standby CP.
.
.
.
Standby CP reboots.
Standby CP booted up.
Standby CP booted up with new firmware.
cp1: Firmwarecommit has started on both Active and Standby CPs.
cp1: Firmwarecommit has completed successfully on Active CP.
cp1: Firmwaredownload command has completed successfully.
switch:admin>
84 Maintaining configurations and firmware
Enter the name or IP address of the server where the firmware file is
stored, for example, 192.1.2.3. You can enter a server name if DNS is
enabled.
Enter the user name of your account on the server, for example,
JohnDoe.
Specify the full path name of the firmware directory, appended by
release.plist, for example, /pub/v5.0.1/release.plist.
Enter your account password for the server.