Rear View - IBM 8865 Installation Manual

Rear view

The following illustration shows the connectors and LEDs on the rear of the server.
AC power
LED
DC power
LED
Power-supply connector: Connect the power cord to this connector.
Video connector: Connect a monitor to this connector.
USB 1 connector: Connect a USB device to this connector.
SP Ethernet 10/100 connector: Use this connector to connect the service
processor to a network.
SP Ethernet 10/100 activity LED: This LED is on the SP Ethernet 10/100
connector. When this LED is lit, it indicates that there is activity between the server
and the network.
SP Ethernet 10/100 link LED: This LED is on the SP Ethernet 10/100 connector.
When this LED is lit, it indicates that there is an active connection on the Ethernet
port.
USB 2 connector: Connect a USB device to this connector.
SP Ethernet 10/100
USB 1
Power-supply
Video
Gigabit Ethernet 1
link LED
Gigabit Ethernet 1
Gigabit Ethernet 1
activity LED
Gigabit Ethernet 2
link LED
Gigabit Ethernet 2
Chapter 3. Server controls, connectors, LEDs, and power
SP Ethernet
10/100 activity LED
SP Ethernet
10/100 link LED
USB 2
System serial
SP serial
Mouse
Keyboard
Remote Supervisor Adapter II
SlimLine error LED
IXA RS485
I/O board error LED
Gigabit Ethernet 2
activity LED
Fan error
LED
29