Table of Contents
Advertisement
Figure 14 Four-Port Copper Gigabit Ethernet NIC Front Panel Details
Figure 15 Two-Port Copper Gigabit Ethernet NIC Front Panel Details
Note
The two-port copper Gigabit Ethernet NIC you use in IP690 appliance must be the Version 2
type, as indicated on the right end of the NIC faceplate. These NICs are sold by Check Point
under the order code NIF4425.
After the power is turned on and the cables are connected, the Ethernet Link LEDs on both the
IP690 and on the remote equipment illuminate to indicate the connection.
Note
The Link LED on the NIC is bicolored. A green LED indicates a 1 Gbps link speed, and a
yellow LED indicates a 10/100 Mbps link speed. As the NIC transmits data, the activity LEDs
on the appliance illuminate.
Copper Gigabit Ethernet NIC Connectors and Cables
The copper Gigabit Ethernet NIC receptacles are for RJ-45 connectors.
Check Point IP690 Security Platform Installation Guide
1
1
2
3
4
Link LED (solid green)
Activity LED (blinking green)
Link LEDs (green or yellow)
Activity LEDs (yellow)
Ports
Two-Port and Four-Port Copper Gigabit Ethernet NIC
RJ-45 receptacles
2
3
4
00641
51
Advertisement
Table of Contents
Troubleshooting
