Table of Contents
Advertisement
Caution
You must place the new battery into the battery holder observing the correct polarity.
The positive terminal of the battery must be facing up.
9. Slowly slide the chassis tray assembly back into the appliance, taking care to prevent
damaging components.
10. Resecure the chassis tray assembly retaining screws.
11. Turn on the power supplies at the back of the appliance.
The appliance should start up normally with the new battery installed. If it does not, repeat
step 1
Point Support Center at http://support.checkpoint.com/.
12. Reset the appliance date and time information by using Check Point Network Voyager or the
command-line interface. The battery is required to maintain the date and time whenever you
shut down the appliance.
Check Point IP690 Security Platform Installation Guide
SL
OT
1
SL
OT
2
SL
OT
3
through
step
11. If the appliance does not start up normally after that, see the Check
1
3
2
SL
4
OT
4
Replacing the Battery
00583
97
Advertisement
Table of Contents
Troubleshooting
