Using Check Point Network Voyager; Viewing Check Point Ipso Documentation By Using Check Point Network Voyager - Check Point IP690 - Flash Based Sys Installation Manual

3
Performing the Initial Configuration

Using Check Point Network Voyager

Use Check Point Network Voyager to configure and monitor your appliance.
To open Check Point Network Voyager
1. Open a Web browser on the host you plan to use to configure or monitor your appliance.
2. In the Location or Address field, enter the IP address of the initial interface you configured
for the appliance.
You are prompted to enter the admin username and the password you entered when you
performed the initial configuration.
Note
If the username login screen does not open, you might not have a physical network
connection between the host and your appliance, or you might have a network routing
problem. Confirm the information you entered during the initial configuration and check
that all cables are firmly connected. For more information, see the troubleshooting
section in the installation guide for your appliance.
Viewing Check Point IPSO Documentation by Using
Check Point Network Voyager
The following documentation is available from the Check Point Network Voyager interface, as
shown in
Network Voyager Reference Guide—This guide is the comprehensive reference source for
Check Point Network Voyager. To access this source, look at the list in the navigation tree on
the left side of the window (as shown in
Check Point IPSO documentation at the Check Point Support Center at
support.checkpoint.com/.
Network Voyager online help—You can access online help when you use
Network Voyager
Network Voyager
Close button is available at the bottom of each online help window you view.
38
Figure 10:
. Online help is the context-sensitive information source for
. To access online help for the window you are viewing, click Help. A
Figure 10).You can also access this guide and other
Check Point IP690 Security Platform Installation Guide
http://
Check Point
Check Point