Using The Iscsi Wizard - Cisco DS-C9216I-K9 Configuration Manual

Chapter 29 Discovering SCSI Targets
Click the drop-down arrow to the right of the pWWN field.
Step 5
Choose the pWWN of the FC target that will be advertised as an iSCSI virtual target.
Step 6
The drop-down list shows all pWWNs that are logged into the name server.
Choose the iSCSI initiators that will access this virtual target.
Step 7
Choose All if you want all the initiators to access the target. Choose None, and then enter in the numbers
(separated by commas) if you want only certain initiators to access the target.
Click Create to create the virtual target.
Step 8

Using the iSCSI Wizard

You can use the iSCSI Wizard to configure a new or existing initiator on a switch.
To use the iSCSI Wizard, follow these steps:
Double-click on the iSCSI Wizard icon on the Fabric Manager toolbar (see
Step 1
Figure 29-1
Step 2 Choose an existing initiator from the list, or enter the iqn name or IP address of the initiator, and enter
the IP address of the switch on which you want to configure the new initiator.
Step 3 Assign names for the node WWN and port WWN fields.
There are three options. The Auto option assigns the WWN from a pool of about 440,000 WWNs per
switch and is returned to pool when you log out. The Persistent option also assigns the WWN from a
pool. However, when you log out of the switch, the WWIN is not returned to the pool but is saved for
the initiator. The third option is to statically assign the WWN by manually entering WWN that the
initiator will use.
Click Finish to create the initiator.
Step 4
OL-7753-01
iSCSI Wizard Icon
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
Using the iSCSI Wizard
Figure 29-1).
29-5