Connecting To External Devices; Connecting To The Computer - HP LD4200tm - Widescreen LCD Interactive Digital Signage Display User Manual

Connecting to External Devices

Connecting to the Computer

1. Be sure the monitor, computer and all attached devices are turned off.
2. Connect the signal input cable:
a. For analog operation, connect the VGA (D-sub) signal cable to the RGB IN (1) connector on
the rear of the monitor and the other end to the VGA connector (2) on the computer.
NOTE:
Figure 3-13
b. For digital operation, connect the HDMI to DVI signal cable (not included) to the HDMI/DVI
(1) connector on the rear of the monitor and the other end to the DVI connector (2) on the
computer.
NOTE:
compliance for this product.
Figure 3-14
3. Connect the audio cable (sold separately) to the Audio (RGB/DVI) (1) connector on the rear of the
monitor and the other end to the line out jack (2) on the computer.
Figure 3-15
NOTE:
cable. As shown in the image, fit the ferrite core to the audio cable. The ferrite core needs to be
separated from the mold by 5 centimeters.
ENWW
If connecting to a Mac computer, use the standard Macintosh adapter (3).
Connecting the VGA Signal Cable
Use shielded signal interface cables with ferrite cores to maintain standard
Connecting the HDMI to DVI Signal Cable
Connecting the Audio
The ferrite core can be used to reduce electromagnetic waves when connecting an audio
Connecting to External Devices 11