Connecting To External Devices - HP LD4201 User Manual

Connecting to external devices

1.
Be sure that the display, media player/computer, and all attached devices are turned off.
2.
Connect the signal input cable.
For additional information, refer to one of the following signal input cable sections:
Connecting RGB on page 22
●
Connecting DisplayPort (480p/576p/720p/1080i/1080p) on page 23
●
Connecting HDMI (480p/576p/720p/1080i/1080p) on page 23
●
Connecting LAN (HP LD4210 and HP LD4710 only) on page 25
●
3. Connect the audio cable (sold separately) to the Audio (RGB/DVI) (1) connector on the rear of the
display and the other end to the Line Out port (2) on the media player/computer if the video
signal connection is from either a RGB (VGA) or DVI connector on the media player/computer.
Figure 3-21
1
NOTE:
cable. Fit the ferrite core to the audio cable. The ferrite core needs to be separated from the mold
by 5 cm (2 in).
ENWW
Connecting the audio cable
The ferrite core can be used to reduce electromagnetic waves when connecting an audio
2
Connecting to external devices
19