Power (Command : A); Input Select (Command : B) (Main Picture Input) - HP LD4200tm - Widescreen LCD Interactive Digital Signage Display User Manual

[Command2][ ][Set ID][ ][OK][Data][x]
*The Product transmits ACK (acknowledgement) based on this format when receiving normal data. At
this time, if the data is in data read mode, it indicates present status data.
If the data is in data write mode, it returns the data of the PC computer.
Error Acknowledgement
[Command2][ ][Set ID][ ][NG][Data][x]
*If there is error, it returns NG

01. Power (Command : a)

To control Power On/Off of the Set.
Transmission
[k][a][ ][Set ID][ ][Data][Cr]
Data 0 : Power Off 1 : Power On
Acknowledgement
[a][ ][Set ID][ ][OK][Data][x]
To show the status of Power On/Off.
Transmission
[k][a][ ][Set ID][ ][FF][Cr]
Acknowledgement
[a][ ][Set ID][ ][OK][Data][x]
Data 0 : Power Off 1 : Power On

02. Input Select (Command : b) (Main Picture Input)

To select input source for the Set.
You can also select an input source using the INPUT button on the remote control.
Transmission
ENWW Transmission / Receiving Protocol 51