Connecting To External Devices - HP LD4201 User Manual

Connecting to external devices

1. Be sure that the display, media player/computer, and all attached devices are turned off.
2. Connect the signal input cable.
For additional information, see one of the following signal input cable sections:
Connecting RGB on page 20
Connecting DisplayPort (480p/576p/720p/1080i/1080p) on page 20
Connecting HDMI (480p/576p/720p/1080i/1080p) on page 21
Connecting LAN (HP LD4210 and HP LD4710 only) on page 22
3. Connect the audio cable (sold separately) to the Audio (RGB/DVI) (1) connector on the rear of
the display and the other end to the Line Out port (2) on the media player/computer if the video
signal connection is from either a RGB (VGA) or DVI connector on the media player/computer.
Figure 3-15
1
NOTE:
audio cable. As shown in the image, fit the ferrite core to the audio cable. The ferrite core needs
to be separated from the mold by 5 cm (2 in).
4. Connect the AC power cord to the AC-IN connector (1) on the rear of the display and the other
end to an electrical outlet (2). Before connecting the power cord, please read the power-cord
safety precautions in the
[Author note:]I have removed the Warning message that appeared below this step,
because it was identical to the Warning in the "Important safety information" section;
instead, I have referenced this safety section that contains the Warning message. Is this
ok?
Figure 3-16
graphic of the power cord.
2
18 Chapter 3 Setting up the display
2nd Draft
Connecting the audio
The ferrite core can be used to reduce electromagnetic waves when connecting an
Important safety information on page
Connecting the power
2
cord[Author note:]Update graphic —Needs a new
1
3.
ENWW