Installing Msa-Specific Components On The Servers - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Configuration Procedures - Linux Environments

Installing MSA-specific components on the servers

Because these installation processes involve updating the server configuration, HP
recommends performing these tasks during inactive periods.
MSA-specific components include:
■
■
■
■
Note:
a server upgrade or move), disconnect the MSA from the SAN. If the MSA is
unconfigured, the MSA can be connected to the SAN.
To install these components on the server, do the following:
1. With the HBAs installed in the server, power on the server and start up the
2. From the console, log on as the root user.
3. Insert the Support Software CD in the CD-ROM drive of the server.
Note:
CD-ROM drive of the server and do not use the shipping version of the CD. For more
information, see:
"Determine which version MSA controller firmware to
■
"Obtain desired controller firmware and Support Software CD
■
4. Mount the CD-ROM drive and view the contents of the CD.
5. Locate and read the
74
HBA drivers (and multipathing tool, if needed)
HP System Management Homepage
Array Configuration Utility (ACU)
Array Configuration Utility - Command Line Interface (ACU-CLI)
If LUNs on the MSA are already being presented to the server (when performing
Linux operating system.
If you created a new Support Software CD from the Web, insert that CD in the
readme.txt
supplement this guide.
file to review notes and information that
HP StorageWorks 1500 Modular Smart Array Installation Guide
use" on page 17
versions" on page 61