Verify The Operating Status Of The Msa; View The Leds On The Msa - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Installation Procedures - All Deployments
8. Verify that each component in the SAN is operating properly.

Verify the operating status of the MSA

To verify the operating status of the MSA:
■
■

View the LEDs on the MSA

Each module of the MSA is equipped with LEDs. To verify that your MSA is
operating properly, look for the following LED patterns:
Table 7: MSA1500 Startup Status Lights
Power switch
Power supply module
Fan module
Fibre Channel I/O module (top LED)
SCSI I/O module (top LED)
If the above LED patterns are not illuminated:
■
■
■
■
■
58
Caution: When you power on the server, the monitor may display a "New
Hardware Found" message and prompt to install an HBA driver. Cancel out of
this window to prevent the installation of an unsupported HBA driver.
View the LEDs on the MSA
Read the messages on the controller display panel
LED
Check your cable connections between the device and the MSA.
Check the availability of your power source.
Review the setup instructions in the previous sections of this guide.
Remove and reinsert the module.
Refer to the HP StorageWorks MSA1500 Maintenance and Service Guide,
available on the Documentation CD and the Technical documents page of the
MSA1500 website: http://www.hp.com/go/msa1500cs.
Amber = standby power
Solid green = power on
Solid green
Solid green
Solid green
Solid green
HP StorageWorks 1500 Modular Smart Array Installation Guide
Condition