HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual page 76

Configuration Procedures - Linux Environments
8. To install the Array Configuration Utility (ACU):
Note:
You must remove earlier versions of the ACU before installing later versions.
■
You must install the HP System Management Homepage before installing the ACU.
■
For information about using the ACU or the ACU-CLI, see ACU online help or the
■
HP Array Configuration Utility User Guide.
Note:
These messages do not affect the MSA and may safely be ignored.
9. To install the Array Configuration Utility - Command Line Interface:
76
e. Install the System Management Homepage by entering:
rpm -ivh <SMH_rpm_filename>
(Where
<SMH_rpm_filename>
Homepage rpm.)
a. Navigate to the /ACU/Linux/x86 directory on the CD.
b. List the contents of the directory and identify the ACU installation rpm
file for your environment.
c. Install the ACU by entering:
rpm -ivh <ACU_rpm_filename>
(Where
<ACU_rpm_filename>
Warning messages regarding driver version dependencies may be displayed.
d. Start the ACU by entering one of the following commands:
— To enable remote access, enter:
— To disable remote access, enter:
a. Navigate to the /HPACUCLI/Linux directory on the CD.
b. List the contents of the directory and identify the directory for your
processor type.
c. Change to the CD directory for your processor type and list the contents
of the directory.
is the name of the System Management
is the name of the ACU rpm.)
/usr/sbin/cpqacuxe -R
/usr/sbin/cpqacuxe -d
HP StorageWorks 1500 Modular Smart Array Installation Guide