HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual page 70

Configuration Procedures - Windows Environments
Important:
Support Software CD from the CD-ROM drive and restart the server. Then, re-insert the
MSA Support Software CD and access the CD main menu.
Important:
Software CD from the CD-ROM drive and restart the server.
5. After all desired components are installed, remove the Support Software CD
6. Restart the server.
7. Repeat these installation procedures on each Windows server that will access
Note:
From the desktop, click Start>Programs>HP System Tools>hp Array Configuration
■
Utility>Set up hp Array Configuration Utility.
Click Next to set the execution mode (be sure to select Local Application), and then
■
enter passwords, the device trust mode, and remote access settings.
For complete information about using the ACU to configure the storage, see ACU online
help or the
70
b. Install the following component (required):
— HBA driver (and the included Windows Event Notification Service)
After installing the HBA and Event Notification Service drivers, remove the
c. Install the following optional components (recommended):
— Array Configuration Utility (ACU)
— Array Configuration Utility-Command Line Interface (ACU-CLI)
— Array Diagnostic Utility (ADU)
d. In multipathing environments, install the following components (required
in all dual-controller configurations):
— MPIO Full Featured DSM
— Multipath Manager
When installing the MPIO components, if prompted, remove the Support
from the CD-ROM drive.
the MSA.
To initially start the ACU and enter basic settings, do the following:
HP Array Configuration Utility User Guide
HP StorageWorks 1500 Modular Smart Array Installation Guide
.