Installing The Acu-Cli On The Servers (Optional) - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Configuration Procedures - HP-UX Environments

Installing the ACU-CLI on the servers (optional)

To use the ACU-CLI to configure MSA storage, perform the following steps to
install it on the servers:
Note:
You must remove earlier versions of the ACU before installing later versions.
■
For information about using the ACU-CLI, see ACU-CLI online help, the HP-UX
■
ACU-CLI readme file or release notes, or the HP Configuring Arrays Reference
Guide.
1. Insert the Support Software CD in the CD-ROM drive of the server.
Note:
CD-ROM drive of the server and do not use the shipping version of the CD. For more
information, see:
"Determine which version MSA controller firmware to
■
"Obtain desired controller firmware and Support Software CD
■
2. From the console, mount the CD-ROM drive and navigate to the
3. List the contents of the directory and identify the ACU-CLI depot file for your
4. Copy the ACU-CLI depot file and its corresponding readme file to a
5. Install the ACU-CLI application using the swinstall command. For example:
6. Remove the Support Software CD from the CD-ROM drive.
Note:
/opt/compaq/hpacucli/bld directory, and then enter # ./hpacucli
84
If you created a new Support Software CD from the Web, insert that CD in the
/HPUXACUCLI/HP-UX
environment.
temporary directory on the server. For example:
# cp /HPACUCLI/HP-UX/IA64/HPACUCLI_IA_v7.47-1.depot .tmp
# swinstall -s /tmp/HPACUCLI_IA_v7.47-1.depot
To start the ACU-CLI, do the following from the console: Navigate to the
directory for your environment.
HP StorageWorks 1500 Modular Smart Array Installation Guide
use" on page 17
versions" on page 61
.