Installing Msa-Specific Components On The Servers - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Configuration Procedures - Windows Environments

Installing MSA-specific components on the servers

Because these installation processes involve updating the server configuration, HP
recommends performing these tasks during inactive periods.
MSA-specific components include:
■
■
■
■
■
■
To install these components on the server, do the following:
1. With the HBAs installed in the server, power on the server and start your
Note:
an HBA driver that is unsupported for use with the MSA.
2. Insert the MSA Support Software CD in the CD-ROM drive of the server and
Note:
CD-ROM drive of the server and do not use the shipping version of the CD. For more
information, see:
Determine which version MSA controller firmware to
■
Obtain desired controller firmware and Support Software CD
■
68
HBA drivers
Array Configuration Utility (ACU)
Array Configuration Utility-Command Line Interface (ACU-CLI)
(The ACU-CLI is not supported on IA64 platforms.)
Array Diagnostic Utility (ADU)
HP MPIO Full Featured Device Specific Module (DSM)
HP MPIO DSM (Device Specific Module) Manager
Windows operating system.
If the New Hardware Wizard is displayed, click Cancel to prevent installation of
let it auto-start the installation program. If the CD does not start automatically,
access the CD-ROM drive, browse the directory of the CD, and execute the
setup.exe file on the CD.
If you created a new Support Software CD from the Web, insert that CD in the
The installation program scans the server to identify the HBAs and determine
which driver to install. This scan may take a few moments.
HP StorageWorks 1500 Modular Smart Array Installation Guide
use, page 17
versions, page 61