Brother IntelliFax-2600 Service Manual page 17

Installing the update data onto the flash ROM of the facsimile equipment
NOTE: The following is an installation procedure example on a PC that is running Windows 95/98.
(1) Copy the update data and transfer utility onto the desired directory of the hard disk.
e.g., C:\UPDATE
(2) Click the Start button, point to Programs, and then click MS-DOS Prompt to open an MS-
DOS window.
(3) Type the drive letter where the update data and transfer utility are located. In the above
example, type C:\ from the command line and press the ENTER key.
Then type CD UPDATE and press the ENTER key.
(4) Check that your computer is connected with the facsimile equipment correctly.
(5) To start the transfer utility transmitting the update data to the flash ROM of the facsimile
equipment, type the following:
ICEN filename /b
Then press the ENTER key.
During downloading, the equipment beeps intermittently.
Upon completion of the downloading, the equipment beeps continuously.
NOTE: If the facsimile equipment cannot return to the standby state after completion of
downloading, turn the power off and on.
II - 2