Brother IntelliFax-2600 Service Manual page 141

Messages on the LCD
DOCUMENT JAM
CLEAN UP SCANNER
SCANNER ERROR
TONER LOW
TONER EMPTY
SET CARTRIDGE
COOLING DOWN
PLEASE WAIT
(Appear alternately.)
MACHINE ERROR XX
CHANGE DRUM SOON
PC BUSY OR FAIL
Document loading error
(1) The document rear sensor detects no leading edge of a
document within 10 seconds from the start of document
loading operation.
(The document rear sensor stays OFF even after the
document has been fed when the document front sensor
was ON.)
(2) The loaded document is too short.
(Since the document is shorter than the distance between
the document front and rear sensors, the document front
sensor is turned OFF before the document rear sensor is
turned ON.)
In the scanning compensation data list printed by the mainte-
nance-mode function code 05, less than fifty percent of the white
level data is faulty.
(This message may appear only in the maintenance mode.)
In the scanning compensation data list printed by the
maintenance-mode function code 05, fifty percent or more of the
white level data is faulty.
(This message may appear only in the maintenance mode.)
The toner sensor has detected that there is not enough toner.
The toner sensor has detected that there is no toner. If this
message appears, recording is no longer possible.
The toner sensor has detected that no toner cartridge is loaded.
The toner thermister has detected that the toner temperature
exceeded the specified level. If the temperature exceeds the
preset level, recording is no longer possible.
"XX" indicates an error code. Refer to [ 2 ] on pages VI-4 and
VI-5.
The service life of the drum unit will expire soon. This message
appears for one minute.
(You can turn this message indication on or off by the
maintenance-mode function code 10, WSW31, selector 8.
Refer to Chapter V, Section 3.5.)
After connected with the host computer, the equipment has
received no response from the computer. (A communications
error has occurred.)
VI - 2
Probable Cause