Installing The Bezel Assembly - IBM LS21 - BladeCenter - 7971 Installation And User Manual

Installing the bezel assembly

The following illustration shows how to install the blade server bezel assembly. The
illustration and instructions also apply to the MPE bezel assembly, except that the
MPE does not have a control-panel connector.
Bezel-assembly
release (both sides)
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. If installing the bezel assembly on a blade server, connect the control-panel
3. Carefully slide the bezel assembly onto the blade server, or MPE, until it clicks
page 17.
cable to the control-panel connector on the system board.
Note: The MPE does not have a control-panel connector.
into place.
Bezel assembly
Control-panel
cable
Control-panel
connector
Chapter 3. Installing options
37