Table of Contents
Advertisement
Closing the blade server cover
Attention:
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustration shows how to close the blade server cover.
To close the blade server cover, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. If you removed the bezel assembly, replace it now (see "Installing the bezel
3. If you removed an expansion unit from a double-width type blade server,
4. Lower the cover so that the slots at the rear slide down onto the pins at the rear
5. Pivot the cover to the closed position, as shown in the illustration, until it clicks
You cannot insert the blade server into the BladeCenter unit until the
Blade-cover
release
page 17.
assembly" on page 37 for instructions).
replace it now (see "Installing an expansion unit" on page 38 for instructions).
of the blade server, as shown in the illustration. Before closing the cover, make
sure that all components are installed and seated correctly and that you have
not left loose tools or parts inside the blade server.
into place.
Blade-cover
release
Chapter 3. Installing options
39
Advertisement
Table of Contents
