Completing The Installation - IBM LS21 - BladeCenter - 7971 Installation And User Manual

Completing the installation

To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see "Installing the
2. If you removed an expansion unit from a double-width type blade server,
3. Close the blade server cover, unless you installed an optional expansion unit
4. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
5. Turn on the blade server (see "Turning on the blade server" on page 13).
6. For certain options, run the blade server Configuration/Setup Utility program
36
BladeCenter LS21 Type 7971 and LS41 Type 7972: Installation and User's Guide
bezel assembly" on page 37).
reinstall the expansion unit (see "Installing an expansion unit" on page 38).
(see "Closing the blade server cover" on page 39).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
server in a BladeCenter unit" on page 40).
(see Chapter 4, "Configuring the blade server," on page 43).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade
server flashes slowly before you press the power-control button.