Removing The Bezel Assembly - IBM LS21 - BladeCenter - 7971 Installation And User Manual

Removing the bezel assembly

To install certain options, you must first remove the bezel assembly. The following
illustration shows how to remove the blade server bezel assembly. The illustration
and instructions also apply to the MPE bezel assembly, except that the MPE does
not have a control-panel connector.
Bezel-assembly
release (both sides)
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Open the blade server cover (see "Opening the blade server cover" on page 20
3. If you are removing the bezel assembly from the blade server and an expansion
4. Press the bezel-assembly release and pull the bezel assembly away from the
5. If you are removing the bezel assembly from the blade server, disconnect the
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.
22
BladeCenter LS21 Type 7971 and LS41 Type 7972: Installation and User's Guide
page 17.
for instructions).
unit is connected to the blade server, remove the expansion unit (see
"Removing an expansion unit" on page 21).
blade server approximately 1.2 cm (0.5 inch).
control-panel cable from the control-panel connector.
Bezel assembly
Control-panel
cable
Control-panel
connector