Replacing The Battery - IBM HS40 - BladeCenter - 8839 Installation And User Manual

Note: The illustrations used in this procedure depict the installation process on a
BladeCenter HS40 blade server in a BladeCenter Type 8677 unit. These
illustrations might differ slightly from your hardware. However, this installation
process is the same regardless of the BladeCenter unit.
Attention:
unit for more than 1 minute without either a hot-swap hard disk drive or a filler
panel installed in each storage expansion unit bay.
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Locate the defective hard disk drive (look for an amber status LED on the front
3. Make sure that the hard disk drive has stopped spinning.
4. Move the handle on the hard disk drive to the open position (perpendicular to
5. Within 1 minute, install the replacement hard disk drive in the hot-swap bay (see

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
42
BladeCenter HS40 Type 8839: Installation and User's Guide
Hard disk drive
Filler panel
To maintain proper system cooling, do not operate the BladeCenter
on page 21.
of the hard disk drive).
the hard disk drive), and pull the hot-swap hard disk drive assembly from the
bay.
"Installing a SCSI hot-swap hard disk drive" on page 40 for instructions).
Blade server
Storage
expansion unit