Removing The Blade Server From The Bladecenter Unit - IBM HS40 - BladeCenter - 8839 Installation And User Manual

v Do not leave the device where others can handle and possibly damage the
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into your blade server
v Take additional care when handling devices during cold weather. Heating reduces

Removing the blade server from the BladeCenter unit

The following illustration shows how to remove the blade server from the
BladeCenter unit.
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. Unless otherwise stated, references to the BladeCenter unit also apply to the
22
BladeCenter HS40 Type 8839: Installation and User's Guide
device.
metal part of the BladeCenter unit or any unpainted metal surface on any other
grounded rack component in the rack you are installing the device in for at least
2 seconds. This drains static electricity from the package and from your body.
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your blade server cover or
on a metal table.
indoor humidity and increases static electricity.
BladeCenter T unit.
Type 8677