Table of Contents
Advertisement
Figure 119. 4 x 3.5-inch hot-swap hard disk drive backplane removal
7. Disconnect all cables from the hard disk drive backplane.
Results
If you are instructed to return the hard disk drive backplane, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing a hot-swap hard disk drive backplane
Use this information to replace a hot-swap hard disk drive backplane.
About this task
To install the replacement hot-swap hard disk drive backplane, complete the
following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 122.
2. Reconnect the cables to the hard disk drive backplane.
3. Install the hot-swap hard disk drive backplane. Based on the server
configuration, the hot-swap hard disk drive backplane may appear as either of
the following three.
Steps for installing a 4 x 2.5-inch hot-swap hard disk drive backplane.
Note: Two 4 x 2.5-inch hot-swap hard disk drive backplanes are used for the
eight 2.5-inch hard disk drive server configuration.
a. Align the backplane with the slots on the chassis.
4 x 3.5-inch hard disk drive backplane
Chapter 5. Removing and replacing components
203
Advertisement
Table of Contents
Troubleshooting
