Teac HS-2 Technical Information page 27

DIRECT MARK SKIP PRESET
Causes the controlled device to skip marks by specifying the mark number.
After skipping, the device will maintain the mode in which it was when the operation began.
Command 7F
Category Code 03
Sub Command 23
Machine ID 0
Data 4 bytes
Data 5
Data 6
Data 7
Data 8
・ If a mark number not existing in the current take is specified, the connected device will transmit ILLEGAL
[F2].
Return none
MARK No. STATUS SENSE
Requests that the current mark number be returned.
Command 7F
Category Code 03
Sub Command 55
Machine ID 0
Data none
Return MARK No. RETURN [FF03D5]
MARK TIME SENSE
Requests that the specified mark time be returned.
Command 7F
Category Code 03
Sub Command 58
Machine ID 0
Data 4 bytes
Data 5
Data 6
Data 7
Data 8
・ If a mark number not existing in the current take is specified, the connected device will transmit ILLEGAL
[F2].
Return MARK TIME RETURN [FF03D8]
Description Remarks
Tens digit of the
mark number
Ones digit of the
mark number Mark number
Thousands digit of
the mark number
Hundreds digit of the
mark number
Description
Tens digit of the specified number
Ones digit of the specified number
Thousands digit of the specified number
Hundreds digit of the specified number
TASCAM HS-8 RS-232C Protocol Specification
Example) 9900: mark 99
Remarks
Mark number
Example) 9900: mark 99
27 TEAC Corporation