HP 6400/8400 User Manual page 98

Table 21 Error Messages (continued)
Status Code Value
39
Time Not Set
40
Not a Supported Version
41
No Logical Disk for Vdisk
42
Logical disk Presented
43
Operation Denied On Slave
44
Not licensed for data replication
45
Not DR group member
46
Invalid DR mode
47
The target DR member is in full
copy, operation rejected
48
Security credentials needed.
Please update your system's ID
and password in the Storage
System Access menu.
49
Security credentials supplied
were invalid. Please update your
system's ID and password in the
Storage System Access menu.
50
Security credentials supplied
were invalid. Please update your
system's ID and password in the
Storage System Access menu.
51
Storage system connection down
52
DR group empty
53
Incompatible attribute
54
Vdisk is a DR group member
98 Error messages
Meaning
The storage system time is not set. The
storage system time is set automatically by
the management software.
The requested operation is not supported by
this firmware version. This can indicate a
user or program error.
The specified SCVD does not have a logical
disk associated with it. This can indicate a
user or program error.
The virtual disk specified is already
presented to the client and the requested
operation is not allowed.
The request is not allowed on the slave
controller. This can indicate a user or
program error.
This error is no longer supported.
The operation cannot be performed because
the virtual disk is not a member of a
Continuous Access group.
The operation cannot be performed because
the Continuous Access group is not in the
required mode.
The operation cannot be performed because
at least one of the virtual disk members is in
a copying state.
The management software is unable to log
in to the storage system. The storage system
password has been configured.
The management software is unable to login
to the device. The storage system password
may have been re-configured or removed.
The management software is already logged
in to the device. (This message is
informational only.)
The Continuous Access group is not
functioning.
.
No virtual disks are members of the
Continuous Access group.
The request cannot be performed because
one or more of the attributes specified is
incompatible.
The requested operation cannot be
performed on a virtual disk that is already
a member of a data replication group.
How to Correct
Report the error to product support.
Report the error to product support.
Report the error to product support.
Delete the associated presentation(s)
and retry the request.
Report the error to product support.
Report the error to product support.
Configure the virtual disk to be a
member of a Continuous Access group
and retry the request.
Configure the Continuous Access
group correctly and retry the request.
Wait for the copying state to complete
and retry the request.
Use the management software to save
the password specified so
communication can proceed.
Use the management software to set
the password to match the device so
communication can proceed.
No action required.
Verify that devices are powered on
and that device hardware connections
are functioning correctly.
Add one or more virtual disks as
members and retry the request.
Retry the request with valid attributes
for the operation.
Remove the virtual disk as a member
of a data replication group and retry
the request.