HP 6400/8400 User Manual page 26

If the feet are not fully raised, complete the following procedure:
1. Raise one foot by turning the leveler foot hex nut counterclockwise until the weight of the rack
is fully on the caster (see
2. Repeat Step 1
Figure 21 Raising a leveler foot
1. Hex nut
3. Carefully move the rack to the installation area and position it to provide the necessary service
areas (see
To stabilize the rack when it is in the final installation location:
1. Use a wrench to lower the foot by turning the leveler foot hex nut clockwise until the caster
does not touch the floor. Repeat for the other feet.
2. After lowering the feet, check the rack to ensure it is stable and level.
3. Adjust the feet as necessary to ensure the rack is stable and level.
26 EVA6400/8400 hardware
Figure 21 (page
for the other feet.
Figure 20 (page 25)).
26)).
2. Leveler foot