Oki CX3641MFP Technical Reference page 53

1 Place grayscale strip
face down
2 Place color measurement
page face down over
grayscale strip
T
O REMOVE CALIBRATION FROM THE COPIER
C
ALIBRATION
12 When prompted on the copier/printer touch panel, place the Kodak Gray Scale strip
face-down on the copier/printer glass.
Place the strip along the top edge of the copier/printer so that it is centered between the
paper width marks on the copier/printer.
1
13 Place the color measurement page face-down over the grayscale strip.
Make sure the patches on the grayscale strip do not overlap the color patches.
Close the platen glass cover, being careful not to move the grayscale strip and color
measurement page.
14 On the copier/printer touch panel, choose OK.
Status messages display the progress of scanning and calculating measurements.
15 When prompted to Print Comparison Page (Expert Mode only), choose Yes to print a preview
of the selected calibration.
Choose from a list of output profiles that use the same calibration set and press OK.
This option appears only in Expert Mode calibration.
16 When prompted to apply or overwrite the calibration, choose Yes.
17 Choose Yes to confirm.
Status messages display progress information. When calibration is complete, the copier/
printer touch panel display returns to the Functions menu.
1 From the copier/printer touch panel, access the Calibration menu as described on
2 Choose Remove Calibration.
3 When prompted, verify that you want to proceed with removing calibration.
The current measurements are removed and a default calibration is restored.
2
/
PRINTER TOUCH PANEL
53
page 52.