Oki CX3641MFP Technical Reference page 45

C
ALIBRATION
10 Feed the measurement page into the DTP41, starting with the cyan strip.
Align the page in the measurement page slot of the DTP41 so that the appropriate color
column is centered below the alignment mark. Insert the page about three inches, past the
front idler rollers, until it rests against the rear drive rollers and you feel resistance.
11 Click Read Strip.
The DTP41 pulls the measurement page through automatically.
After the measurement page is read, Calibrator instructs you to insert and align the page
again for the next color.
12 Repeat the measurement process for the magenta, yellow, and black strips.
A check mark appears on the circle of the color just read, and the Status field indicates the
color was measured successfully.
Use the Previous and Next buttons to reverse or advance to another step in the
measurement sequence.
13 When the Status field indicates that all four color strips have been read successfully, click
Accept Measurements.
14 Click OK in the Measure dialog box.
15 Click Apply in the Calibrator dialog box to implement the new calibration set.
45