Returning The Unit To Local Control Mode - TANDBERG TT-1222 Reference Manual

Operating the Equipment Remotely
Once the communication parameters are entered correctly, set the system
into remote mode for the external computer to gain control of the unit.
Table 5.2: Activating RS-232 Remote Control
Step
1.
2.
3.
5.2

Returning the Unit to Local Control Mode

Once the unit is in remote control mode, no local controls are available. To
re-acquire local control, it is necessary to set the remote control
parameter back to "local".
Table 5.3: Configuring the Unit for Local Control
Step
1.
2.
3.
Page 5-4
Action
Go to the Control menu, located under
the Setup menu.
Scroll until the item "Ctrl. Mode" is
shown.
Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: "Remote".
Action
Go to the Control menu, located under
the Setup menu.
Scroll until the item "Ctrl. Mode:" is
shown.
Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: "Local".
Result
The display will read "SET:CONTROL" on the top line.
The unit is now ready to accept remote control via the
RS-232 port.
Result
The display will read "SET:CONTROL" on the top line.
The unit is now controlled via the front keypad.
Reference Guide: TT1222 4:2:0 Professional Receiver
ST.RE.TT1222.2