Downloading Drivers - Tandberg Data Storage Library T128 User Manual

If you need to license additional storage slots, contact technical support for license keys to activate the
additional slots. For contact information, see
instructions on licensing storage slots, see
8 Load tape cartridges into the library.
You can use the I/E commands to import tape cartridges into the library or perform an initial bulkload of
the library.
When bulkloading the library, do not insert storage or cleaning tapes into the bottom two rows of the
lowest module in the library configuration. In any library configuration, the picker cannot access the
bottom two slots in each column in the lowest module in the stack due to the fact that there is not enough
clearance at the bottom of the library for the robotic picker.
For instructions on importing tape cartridges, see
bulkloading, see Bulkloading
Removing, and Replacing
9 Connect to the host application.
Set up the connection to the library host application. If your host application inventories the location of
each tape cartridge in the library, open the host application and perform a reinventory to sync the logical
inventory with the physical inventory of the library.
For instructions, see your host application documentation.
10 Register the library.
For more information about registering the library, see
11 Run the library.
You are now ready to start using your library. For information about using your library, see
Library on page 55 and the library's online Help.

Downloading Drivers

You can find drivers for your library at www.tandberg.com.
20
Getting More Information or Help
Applying License Keys
Importing Media
on page 59. For complete installation instructions, see
on page 83.
on page 2. For
on page 43.
on page 58. For information on
Registering the Library on page 54.
Installing,
Running Your
Setting Up the Library