Table of Contents
Advertisement
b. With your free hand, swivel the parking tab away from you until it is removed completely from
the interior of the module. When replaced correctly, the parking tab will not accidentally swivel
into the path of the robot.
c. Gently release the robot assembly. It will lower to the bottom module of the library.
6
Close the library's I/E station and access doors.
7
Connect all power cords, network data cables, and module-to-module cables. Make sure the module
terminators are installed at the top and bottom of the stack of modules. For cabling instructions, see
Cabling the Library
on page 84.
8
Power on the library.
9
Add the tape cartridges to the library's modules using the I/E station commands from the operator panel
or web client.
10 Reconfigure the library settings using the operator panel or web client.
11 Open the host application and reinventory in order to synchronize its logical inventory with the physical
inventory of the library.
114
Installing, Removing, and Replacing
Advertisement
Table of Contents
Need help?
Do you have a question about the Storage Library T128 and is the answer not in the manual?
Questions and answers