Servicing The Lcb Based On Led Status; Tape Drive Leds; Table 11 Amber Led On The Library Control Blade; Figure 15 Location Of Tape Drive Leds - Tandberg Data Storage Library T128 User Manual

Table 11 indicates the actions you can take, based on the condition of the LED.
Table 11 Amber LED on the Library Control Blade
State of Amber LED
Solid on for 10+
minutes
1 blink per second

Servicing the LCB Based on LED Status

1 Observe the blinking patterns of the LEDs for at least 30 seconds.
2 Capture a snapshot of the library, and send it to technical support for analysis.

Tape Drive LEDs

RAS tickets typically report all problems related to tape drives, including error codes and tape alerts. By
observing the blinking pattern of LEDs on tape drives, however, you can discern which operation the tape
drive is currently performing.
Figure 15 shows where the tape drive LEDs and the fibre port link LED are located.
Figure 15 Location of Tape Drive LEDs
Tandberg StorageLibrary T128 User's Guide
Suggested Service Action
Replace the LCB.
Check the firmware for the LCB and make sure that you have the most current
firmware available.
Do not replace the blade. It is unlikely that the LCB hardware is the source of
the problem.
159