Table of Contents
Advertisement
Tandberg Data
10. Continue gently pushing until the assembly is at the bottom of its travel.
11. Insert the four M3 x 6mm flathead Phillips screws that fasten the lower
magazine guide assembly.
12. Attach the ribbon cable to the main PWB and replace the retainer.
13. Replace the right side panel and fasten with 10 M3 x 6mm flat-head Phillips
screws.
78
Chapter 7 – Parts Removal and Replacement
Tandberg SLR Autoloader Service and Repair Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the SLR AUTOLOADER and is the answer not in the manual?
Questions and answers