Tandberg Data SLR AUTOLOADER Service And Repair Manual page 67

Boot Firmware Error Codes
FSC Display Message
B001 Boot ROM CRC Error
B002 Code ROM CRC Error
B003 Boot RAM Test Failed
B004 Boot CPU Test Failed
B005 Boot ENC Test Failed
B006 Boot UART Error
B007 Boot Comm Open
Error
Power-On Self Test Error Codes
FSC Display Message
4001 Uart 1 Error
4002 Uart 2 Error
Menu Mode Error Codes
FSC Display Message
5610 BREAK Detected
5611 DACI Locked
5612 DACI Busy
5613 Drive Busy
5614 Illegal CDB
5615 Illegal Parameters
5617 Unknown Command
5618 DACI Poll Error
5619 Illegal Data
567F Status Timeout
Tandberg SLR Autoloader Service and Repair Manual
Description
A power-up error was
detected.
Description
Internal serial port error Robotics Assembly
Description
Unexpected status
returned from drive.
No response from
drive.
Source of Failure
Robotics Assembly
Source of Failure
Source of Failure
Drive Assembly
Suggested Action
Press the REBOOT
button on the Control
Panel or flash with new
firmware. See Chapter
4.
Suggested Action
Press the REBOOT
button on the Control
Panel.
If this does not correct
the error, contact
Tandberg Data.
Suggested Action
Press the REBOOT
button on the Control
Panel.
63