Tandberg Data SLR AUTOLOADER Service And Repair Manual page 64

Tandberg Data
Control Process Error Codes
FSC Display Message
2001 Ctl Invalid Command An invalid command
2004 Loader Not Ready
2005 SCSI Id Not Set
2008 Illegal Move
2009 Door Open
200A Menu Mode
200C Cart Unaccessible
200D Drive In Error
200F Removal Prevented
2040 Invalid Ctl Msg
60
Description
was received by the
control process.
Command received
while Loader was not
ready.
An attempt to set the
drive SCSI ID failed.
While attempting to
perform a MOVE
operation, the source or
destination locations
were in the wrong state
(FULL or EMPTY).
Also occurs if MOVE is
attempted with an invalid
cartridge map.
A command was
received while door was
open.
A command was
received while unit was
in Menu mode.
An attempt was made to
fetch a cartridge from a
drive not in ejected
state. Applies when
system is config-ured for
explicit unloads.
An attempt was made to
access a drive in an
error state.
An attempt was made to
access a drive in the
Prevent Media Removal
state.
An illegal message type
code was received. Can
be the result of receiving
a NULL type code, a
status code without a
command being active,
or a command code
while a command is
currently active.
Tandberg SLR Autoloader Service and Repair Manual
Chapter 6 - Trobleshooting
Source of Failure
Robotics Assembly Contact Tandberg Data
for new firmware.
Flash with new firm-
ware. See Chapter 4.
Software or operator Press the REBOOT
procedure error button on the Control
Panel.
Drive or robotics Replace the SCSI drive
assembly error or check the firmware
level.
Software or operator Press the REBOOT
procedure error button on the Control
Panel.
Close the door.
Exit the Menu mode
Check host software for
proper function.
Drive or Robotics Reboot the system.
Assembly Replace the drive.
Software or operator Reboot the system.
procedure error Check host software.
Robotics Assembly Press the REBOOT
button on the Control
Panel.
Suggested Action