Running An Installed Cleaning Cartridge; Removing The Cleaning Cartridge - Tandberg Data SLR AUTOLOADER Service And Repair Manual

Tandberg Data

Running an Installed Cleaning Cartridge

Manual Method 1
This method can be used if the Cleaning Slot is disabled in the Setup menu.
Install a cleaning cartridge in slot #8.
1.
2. Use the Load button to load the cleaning cartridge into the drive.
3. When the display changes from Drive Ready to Tape Ejected, you can
Unload the cartridge back to the magazine.
Manual Method 2
1. Make sure that Cleaning Slot is enabled in the Setup Menu. (This
dedicates Slot 8 to cleaning operations.)
2. Install a cleaning cartridge in slot #8.
3. Select Clean Drive from the Maintenance section of the Utilities menu.
Automatic Method
Make sure that Cleaning Slot and Auto Clean are enabled in the Setup Menu.
(This allows the loader to automatically load a cleaning cartridge from slot 8
into the drive whenever it needs cleaning.)

Removing the Cleaning Cartridge

1. Determine whether a cartridge is loaded into the drive. If so, unload it.
2. Remove the magazine from the unit.
3. Remove the cleaning cartridge from the magazine.
4. Insert any desired data cartridge into the slot vacated by a cleaning
cartridge.
Note: The Cleaning Slot must be disabled in the Setup meny to make use of
a data cartridge in slot #8.
5. Insert the magazine into the unit.
6. Close the front panel door.
54 Tandberg SLR Autoloader Service and Repair Manual
Chapter 5 - Maintenance