Break-In - HYOSUNG GV 650 C Owner's Manual

WARNING
Following another vehicle too closely
can lead to a collision. As vehicle
speeds increase, stopping distance
increases progressively.
Be sure you have a safe stopping dis-
tance between you and the vehicle in
front of you.
5. Park the motorcycle on a firm, flat sur-
face where it will not fall over.
WARNING
A hot muffler can burn you. The muffler
will be hot enough to burn you for some
time after stopping the engine.
Park the motorcycle where pedestrians
or children are not likely to touch the
muffler.
6. Turn the ignition switch to the "OFF"
position and remove the ignition key.
7. Turn the handlebar all the way to the left.
8. Insert the ignition key into the steering
lock, and turn it clockwise from the "
position.
9. Remove the ignition key.
This section explains how important prop-
er break-in is to achieve maximum life and
performance from your new Hyosung. The
following guidelines explain proper break-in
procedures.
MAXIMUM THROTTLE OPENING
RECOMMENDATIONS
The table below shows the maximum
throttle opening recommendation during the
break-in period.
Initial 800 km (500 miles)
Up to 1,600 km (1,000 miles)
AVOID CONSTANT LOW SPEED
Operating the engine at constant low
speed(light load) can cause parts to glaze
and not seat in. Allow the engine to acceler-
ate freely through the gears, without
exceeding the recommended maximum
limits. Do not, however, use full throttle for
the first 1,600 km (1,000 miles).
"
VARY THE ENGINE SPEED
The engine speed should be varied and
not held at a constant speed.
This allows the parts to be "loaded" with
pressure and then unloaded, allowing the
parts to cool.
This aids the mating process of the parts.
It is essential that some stress be placed on
the engine components during break-in to
ensure this mating process.
Do not, though, apply excessive load on
the engine.
48

BREAK-IN

Less than 1/2 throttle
Less than 3/4 throttle