HYOSUNG GV 650 C Owner's Manual page 81

2. Put the engine stop switch in the "
position and the ignition switch in the
ON position. Holding the spark plug
base firmly against the engine, the trans-
mission in neutral, the side stand up, the
clutch disengaged and push the electric
starter switch. If the ignition system is
operating properly, a blue spark should
jump across the spark plug gap.
When the ignition switch is set to "ON"
position with the engine stopped, the
meter lamp will come on and the needle
of the speedometer will turn once to the
end as a test of electric system operation.
Push the starter switch after the needle of
the speedometer turn back.
3. If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
4. If there is still no spark, consult your
Hyosung dealer for repairs.
WARNING
Performing the spark test improperly
can be hazardous.
You could get a high voltage electrical
shock or an explosion if you are not
familiar with this procedure.
Do not perform this check if you are not
familiar with the procedure.
Keep the spark plug away from the
spark plug hole during this test. Do not
this test if you have a heart condition or
wear a pacemaker.
ENGINE STALLING
"
Check the fuel supply in the fuel tank.
Check the ignition system for intermit-
tent spark.
Check the engine idle speed.
When any trouble occurs, the best way
is to consult your Hyosung dealer for
repairs.
80
CAUTION