HYOSUNG GV 650 C Owner's Manual page 77

INSPECTION OF LAMPS
Check if the head lamp, position lamp,
meter lamp, tail lamp and license plate
lamp work well when the ignition switch
was turned to the "ON" position.
Check if the brake lamp work well when
the front brak lever or rear brake pedal
was operated.
Check if the turn signal lamp work well
when the turn signal switch was operated.
Check if the head lamp, tail lamp, turn
signal lamp and brake lamp are dusty or
damaged.
Position
lamp
Turn signal lamp
Turn signal lamp
License
plate
lamp
Brake / Tail lamp
CAUTION
The head lamp, position lamp, meter
lamp, tail lamp and license plate lamp on
this motorcycle always comes on when
the ignition switch is turned to the "ON"
position.
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than specification
may cause the electric system or the lamp
to damage.
Head lamp
Position lamp
Brake / Tail lamp
Turn signal lamp
Head lamp
License plate lamp
The use of a lamp other than rules may
cause to occur the vehicle fire and to
damage electric parts.
Surely use only the lamp of proper
capacity.
76
REPLACEMENT OF THE LAMP
NAMES
12V - H4 : 60/55W
LED : Light Emitting Diode
CAUTION
CAPACITY
12V - W5W 1
LED type
12V - RY10W 4
12V - W5W 1
1