HYOSUNG GV 650 C Owner's Manual page 61

To remove the air cleaner :
1. Remove the two screws
2. Remove the air cleaner cover
3. Remove the four screws
cleaner element.
4. Remove the air cleaner element
5. Clean the air cleaner element for the fol-
lowing :
1) When the air cleaner element clean
with the air gun, necessarily blow at
the inside by compressed air.
2) Carefully examine the air cleaner ele-
ment for tears during cleaning.
Replace it with a new one if it is torn.
3) Assemble the element completely or
damage severely the engine.
4) Be careful not to allow water to go
inside the air cleaner element.
Before and during the cleaning opera-
.
tion, inspect the element for tears.
A torn element must be replaced.
Be sure to install the element snugly
and correctly, so that no incoming air
will bypass it.
Remember, rapid wear of the piston
rings and cylinder bore is often caused
by a defective or poorly fitted element.
of the air
.
More frequent servicing may be per-
formed on the motorcycle that are used
under severe conditions, also clean the
air cleaner element when replacing the
oil to prevent damage of the engine.
Operating the engine without the air
cleaner element in place can be haz-
ardous.
Never run the engine without the air
cleaner element in place.
60
CAUTION
CAUTION
When the air cleaner element is not
installed correctly, dust can go inside
and severely damage the engine.
Be careful not to allow water to go
into the element while washing.
CAUTION
WARNING