Bulbs - HYOSUNG GV 650 C Owner's Manual

3. Loosen the drive belt adjuster lock nut
and adjuster , left and right, and disen-
gage the drive belt from the rear pulley.
4. Loosen the rear axle
5. Draw out the rear axle
6. Pull the rear wheel assembly rearward.
7. To reinstall the rear wheel assembly,
reverse the complete sequence listed.
.
.
WARNING
Keep fuel and other flammable sub-
stances away from electric components.
Before changing a bulb, set the ignition
switch to position "OFF" and allow a few
minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the bulb,
as this may lead to overheating and fail-
ure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
N O T E
Before changing a bulb, check the fuses.
75

BULBS

CAUTION