Break-In - HYOSUNG GD250 Owner's Manual

WARNING
Following another vehicle too closely
can lead to a collision. As vehicle
speeds increase, stopping distance
increases progressively.
Be sure you have a safe stopping
distance between you and the vehicle in
front of you.
5. Park the motorcycle on a firm, flat
surface where it will not fall over.
WARNING
A hot muffler can burn you. The muffler
will be hot enough to burn you for
some time after stopping the engine.
Park the motorcycle where pedestrians
or children are not likely to touch the
muffler.
6. Turn the ignition key to the "OFF"
position.
7. Push down the ignition key from the
"OFF" position, come up again and turn
it to the "LOCK" position.
8. Remove the ignition key.

BREAK-IN

This section explains how important
proper break-in is to achieve maximum life
and performance from your new Hyosung.
The following guidelines explain proper
break-in procedures.
★ M AXIMUM THROTTLE
OPENING
RECOMMENDATIONS
The table below shows the maximum
throttle opening recommendation during
the break-in period.
Initial 800 km (500 miles)
Up to 1,600 km (1,000 miles)
★ A VOID CONSTANT LOW
SPEED
Operating the engine at constant low
speed (light load) can cause parts to glaze
and not seat in. Allow the engine to
accelerate freely through the gears, without
exceeding the recommended maximum
limits. Do not, however, use full throttle for
the first 1,600 km (1,000 miles).
52
Less than 1/2 throttle
Less than 3/4 throttle